Details of wall lamp installation

How to install the wall lamp

(1) The installation height of the wall lamp must be slightly higher than the height of the eye level by about 1.8 meters. The illumination of the wall lamp should not be too large. Mainly based on auxiliary lighting and decoration effects.

(2) First determine the height of the room. The installation height of the wall lamp is higher than the line of sight, about 1.8 meters. The height of the wall is 1440-1850 from light to work surface and 2240-2650 from floor to floor.

(3) The distance from the wall lamp in the bedroom to the ground can be very close, about 1400-1700 mm. The wall distance of the wall lamp is also very close, between 95-400 mm, comparing the specific size and actual situation.

Details of wall lamp installation

(1) According to the holes on the wall light plate, mark the position where the expansion screws need to be nailed on the wall, and combine the installation drawings to measure the data accurately to avoid mistakes.

(2) Use an electric drill to drill holes at the marked places on the wall. Know the layout of the circuit in advance, do not drill on the wires, and master the depth of the drilling.

(3) After opening the hole, start tightening the expansion screw. First, push the expansion screw into the hole that has been made, then use a hammer or something to drive the expansion screw into the wall until it all disappears into the wall.

(4) Pass the wood screw through the hole for wall hanging of the wall lamp, fix it on the expansion screw and tighten it. The fixation on both sides is performed alternately to play a stabilizing role, so as not to dislocate the wood screws.

(5) Connect the hanging plate and the suction cup with screws, tighten the head screw, and fix the suction cup firmly. Finally, cut off the indoor power supply, connect the wire and power cord of the wall light, and finally install the wall light.

(6) The installation method of the wall lamp is relatively simple. Generally, after the position is determined, prepare the fixing of the wall lamp socket, and then fix the wall lamp on the wall by means of embedded materials or punching.

(7) The wire connecting the wall lamp is easy to be consistent with the paint color of the wall color. In order to keep the wall clean, you can choose a bright color. Dig a small slot in the wall that fits snugly into the wire, embed the wire, and bury it with lime. Please pay attention to the plans of the railway. Centered on a straight line without bending, apply the paint in the same color as the wall.